Furnace Repair in Chilliwack Same-Day, Licensed.
No heat in Sardis, Promontory, or downtown Chilliwack? A licensed gas fitter from our Chilliwack shop can usually be at your door the same day, with the common parts on the truck.
The Furnace Repair Company Chilliwack Calls First
Full Service Heating & Cooling is based in Chilliwack, not dispatched from Abbotsford or Surrey. That matters on a January morning when the furnace is dead and the house is dropping a degree an hour. Our technicians know the housing stock here, from the older gas furnaces in Fairfield Island and downtown to the newer high-efficiency units in Garrison Crossing and Promontory, and they carry the parts that fail most often on those systems.
Every furnace repair is done by a licensed gas fitter registered with Technical Safety BC, fully insured, and backed by our parts and labour warranty. You get a flat diagnostic fee up front, a written quote before any work starts, and an honest answer on whether the repair is worth it.
- Licensed gas fitters, Technical Safety BC registered
- Based in Chilliwack, same-day service available
- Written quotes before any work starts
Looking for the full picture? Furnace installation and replacement options
Furnace Problems We Fix Every Week in Chilliwack
If any of these sound familiar, call us. Most are single-visit repairs when caught early.
No Heat at All
The thermostat calls for heat but nothing happens. Often an ignitor, flame sensor, or a tripped safety switch. Our most common winter call in Chilliwack.
Short Cycling
The furnace starts, runs a minute or two, and shuts off. Usually a dirty flame sensor, a clogged filter, or an overheating heat exchanger.
Blower Runs, Air Is Cold
The fan is moving air but the burners never light. Points to the ignition system, gas valve, or control board.
Clicking, But No Ignition
Repeated clicking from the furnace is the ignitor trying and failing. It needs attention before it locks the system out entirely.
Yellow Flame or CO Alarm
A yellow, flickering burner flame or a carbon monoxide alarm means shut it down and call. This is a safety issue, not a comfort issue.
FortisBC Bill Climbing
A furnace that runs longer than it used to for the same warmth is losing efficiency. A tune-up or a failing component is usually the cause.
What a Chilliwack Furnace Repair Visit Includes
- Full diagnostic of the ignition, gas, airflow, and safety systems
- Written quote with the repair cost before any work starts
- Repair of ignitors, flame sensors, control boards, blower motors, gas valves, pressure switches, and thermostats
- Service on every major brand: Lennox, Carrier, Goodman, Trane, Rheem, York, Amana, and more
- Carbon monoxide and combustion safety check before we leave
- Honest repair-or-replace advice if the furnace is near end of life
Same-day service. Free, written quotes.
What Makes Furnace Repair in Chilliwack Different
Chilliwack's winter is not just cold, it is wet and windy. Arctic outflow events push down the Fraser Canyon and can drop temperatures well below what the rest of the Lower Mainland sees, and they tend to arrive overnight. That is when furnaces that have been limping along for weeks finally quit, and it is why we keep extra technicians on call from December through February.
The damp also matters. Long stretches of rain and fog mean condensate lines and exhaust venting on high-efficiency furnaces need to be clear and properly sloped, or the furnace shuts itself down on a pressure switch fault. We see this often in Sardis and Vedder Crossing, where a lot of 1990s and 2000s homes have furnaces reaching the end of their service life.
- Extra on-call coverage during arctic outflow cold snaps
- Condensate and venting checks on every high-efficiency furnace call
- Furnace replacements permitted through the City of Chilliwack, handled by us
- Serving Sardis, Vedder, Promontory, Garrison, Yarrow, Rosedale, Cultus Lake, and the Chilliwack River Valley
How a Furnace Repair Call Works
- 01
Call or Book Online
Tell us the symptoms and your neighbourhood. No-heat calls in winter get priority dispatch.
- 02
Same-Day Diagnostic
A licensed gas fitter arrives, tests the system, and explains exactly what failed and why.
- 03
Written Quote
You get the repair price in writing before we touch a tool. The diagnostic fee is applied to the repair if you go ahead.
- 04
Repair and Safety Check
We fix it, verify combustion and carbon monoxide levels, and confirm the furnace cycles properly before we leave.
Furnace Repair Pricing in Chilliwack
Every furnace repair in Chilliwack starts with a flat diagnostic fee that is applied to the repair if you proceed. From there, the cost depends on the part and the labour, and you will see the number in writing before any work begins. If your furnace is more than 15 years old and the repair would cost more than about half of a replacement, we will tell you, because a new high-efficiency furnace with CleanBC and FortisBC rebates is often the better spend.
Current BC rebates- Flat diagnostic fee, applied to the repair
- Written quote before work starts, no surprises
- Repair-or-replace guidance based on age and cost
- High-efficiency furnace rebates handled for you
Furnace Repair in Chilliwack, Common Questions
How quickly can you repair a furnace in Chilliwack?
Most furnace repair calls in Chilliwack are handled the same day, and no-heat calls in winter go to the front of the line. Because our shop is in town, there is no long drive before the work starts, and our trucks carry the ignitors, flame sensors, capacitors, and control boards that fail most often.
My furnace is blowing cold air. Should I turn it off?
If the blower is running but the air is cold, set the thermostat fan to Auto instead of On and check the filter. If it is still blowing cold after that, turn the furnace off at the switch and call us. Running it repeatedly can cause the control board to lock the system out.
Do you repair furnaces in Sardis, Yarrow, and Cultus Lake?
Yes. We service every Chilliwack neighbourhood, including Sardis, Vedder Crossing, Promontory, Garrison Crossing, Yarrow, Greendale, Rosedale, Cultus Lake, Fairfield Island, and the Chilliwack River Valley. Outer areas like Cultus Lake and the River Valley may add a little drive time, but we do not charge extra for them.
Should I repair or replace my furnace?
Our rule of thumb: if the furnace is under 12 years old and the repair is a single component, repair it. If it is over 15 years old, has needed repairs more than once in the last two winters, or the repair would cost more than half of a replacement, a new high-efficiency furnace usually costs less over the next five years, especially with current rebates. We will give you both numbers in writing.
Do I need a permit for furnace work in Chilliwack?
Repairs do not require a permit. A furnace replacement in Chilliwack requires a mechanical permit from the City of Chilliwack and a gas permit through Technical Safety BC. We pull both on your behalf and schedule the final inspection.
What can I check before calling for furnace repair?
Check that the thermostat is set to Heat and above room temperature, that the furnace switch and breaker are on, that the filter is not clogged, and that the exhaust vent outside is not blocked by snow or debris. If none of those fix it, call us. Our article on furnaces not working in Chilliwack walks through these checks in detail.
Need Furnace Repair in Chilliwack Today?
Same-day service, licensed gas fitters, written quotes. Call now or request a visit online.